Call (833) 669-2277

Custom

mitchell1

/CRM Mitchell1

About CRM Mitchell1

This author has not yet filled in any details.
So far CRM Mitchell1 has created 80 blog entries.

2004 BMW 530i

2019-11-15T23:00:48+00:00

BMW 530i

Mileage
232,914
Service Date
11/11/2019
Services Performed
  • Diagnose engine misfire
  • ENGINE COMPRESSION – Testing – All Applicable Models – [NOTE: Add .2 for wet compression retest on gas engines.]
  • SPARK PLUGS – Remove & Replace – All Applicable Models
 
MIKE C. gave our service a 5 star review on 11/13/2019
2004 BMW 530i 2019-11-15T23:00:48+00:00

2014 Fiat 500L

2019-11-12T23:02:15+00:00

Fiat 500L

Mileage
67,276
Service Date
10/31/2019
Services Performed
  • Road test vehicle. Inspect all fluids. Inspect vehicle.
 
Anita T. gave our service a 5 star review on 11/6/2019
2014 Fiat 500L 2019-11-12T23:02:15+00:00

2011 Hyundai Accent

2019-10-23T22:00:46+00:00

Hyundai Accent

Mileage
149,464
Service Date
10/14/2019
Services Performed
  • Clean the master cylinder cap area and remove the old fluid from the reservoir. Fill with fresh fluid and flush by vacuuming old fluid out of each brake bleeder until the fluid is clean
  • COOLING SYSTEM – Flush – All Applicable Models
  • FULL SYNTHETIC OIL CHANGE
  • Road test vehicle. Inspect all fluids. Inspect vehicle.
  • TIRE ROTATION
 
JEFF R. gave our service a 5 star review on 10/22/2019
2011 Hyundai Accent 2019-10-23T22:00:46+00:00

2013 Ford Escape

2019-10-09T22:01:21+00:00

Ford Escape

Mileage
57,668
Service Date
10/4/2019
Services Performed
  • AXLE SHAFT ASSEMBLY – Remove & Install or Remove & Replace – Right – [DOES NOT include alignment.]
  • BATTERY – Remove & Replace – All Applicable Models – [Includes: Test.]
  • Drain oil. Change filter. Fill with synthetic blend oil to correct level.
  • Ensure tires are set to correct pressure. Perform alignment check to obtain initial measurements. Adjust caster, camber, and toe (as applicable) on both axles to manufacturer's specifications with steering wheel set straight. Calibrate steering angle sensor if needed. Perform test drive to ensure accuracy of alignment (repeat procedure if necessary).
  • Front Wipers – Remove and replace – both
  • SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Rear,Both – [DOES NOT include disassemble or alignment.]
 
Kim S. gave our service a 5 star review on 10/7/2019
2013 Ford Escape 2019-10-09T22:01:21+00:00

2016 Ford Escape

2019-09-21T22:02:40+00:00

Ford Escape

Mileage
43,875
Service Date
9/19/2019
Services Performed
  • BATTERY – Remove & Replace – All Applicable Models – [Includes: Test.]
  • Inspect/Recharge Battery and check charging system
 
Angelika B. gave our service a 5 star review on 9/20/2019
2016 Ford Escape 2019-09-21T22:02:40+00:00

2011 Hyundai Santa Fe

2019-09-05T22:00:53+00:00

Hyundai Santa Fe

Mileage
129,442
Service Date
8/30/2019
Services Performed
  • Battery installed. Tested battery, tested new. Performed charging test, result was alternator putting out 14.31V at idle no load and 14.16V at idle full load. Alternator tested normal. No pulley noise at alternator either. Concern of intermittent start solved.
  • Mount and Balance 2 tires w/ purchase
  • TIRE DISPOSAL FEE
  • MD TIRE TAX
 
Donato C. gave our service a 5 star review on 8/31/2019
2011 Hyundai Santa Fe 2019-09-05T22:00:53+00:00

2014 Jeep Cherokee

2019-09-01T22:01:33+00:00

Jeep Cherokee

Mileage
51,320
Service Date
8/30/2019
Services Performed
  • Full Synthetic Oil Change
  • Rotate Tires
  • License Plate Bulb — Remove and replace
  • Clean the master cylinder cap area and remove the old fluid from the reservoir. Fill with fresh fluid and flush by vacuuming old fluid out of each brake bleeder until the fluid is clean
 
Victoria B. gave our service a 5 star review on 8/31/2019
2014 Jeep Cherokee 2019-09-01T22:01:33+00:00

2011 Ford Pickup

2019-08-29T22:01:31+00:00

Ford Pickup

Mileage
87,574
Service Date
8/26/2019
Services Performed
  • Remove battery cables, wire brush and clean connections and terminals. Reassemble and torque to spec.
  • Clean the master cylinder cap area and remove the old fluid from the reservoir. Fill with fresh fluid and flush by vacuuming old fluid out of each brake bleeder until the fluid is clean
  • Remove and replace valve cover gasket. Replace all necessary seals and gaskets related to job. Replace fuel injector feed lines. Test for leaks.
  • Full Synthetic Oil Change
  • ENGINE OIL PRESSURE SWITCH – Remove and replace – F250 Super Duty,F350 Super Duty,Diesel
  • Add chemical flush to system. Allow engine to reach operating temperature. Continue to run for several minutes. Drain coolant. Fill, drain, and cycle with water until clear. Fill with appropriate coolant. Bleed air out of system. Inspect for leaks.
 
CLAY M. gave our service a 5 star review on 8/28/2019
2011 Ford Pickup 2019-08-29T22:01:31+00:00

2011 BMW 528i

2019-08-25T22:01:09+00:00

BMW 528i

Mileage
143,196
Service Date
8/21/2019
Services Performed
  • Manually disengage transmission to allow for portability of vehicle locked in park electronically.
  • Engine compression test was performed dry at first, which yielded no compression. Wet compression retest was performed also yielding no compression. Advised customer. Suggested plan of action is to remove the camshaft to determine whether valves are bent/not sealing.
  • Valve cover removed to gain access to camshaft for removal and further testing of engine/valve integrity. Upon its removal it was discovered that all VANOS bolts have sheared off the VANOS adjustment unit. Large sections of bolt heads were removed from the top of engine, but smaller fragments are still unaccounted for. Advised customer to contact BMW for possible remedy through recall/extended warranty. Work at MMW has been halted pending further instruction. Remedy through MMW is recommended as complete engine replacement due to unknown engine condition and cost effectiveness.
 
Steve S. gave our service a 5 star review on 8/23/2019
2011 BMW 528i 2019-08-25T22:01:09+00:00

2007 Mercedes-Benz C280

2019-08-02T22:00:37+00:00

Mercedes-Benz C280

Mileage
172,941
Service Date
7/26/2019
Services Performed
  • Diagnose No Start/Hard Start
  • FUEL PUMP – Remove and Replace – All Applicable Models
  • Full Synthetic Oil Change
  • ENGINE OIL COOLER – Remove and Replace – All Applicable Models – [DOES NOT include flush systems.]
  • COOLING SYSTEM FLUSH W/KIT
 
STEPHEN D. gave our service a 5 star review on 7/31/2019
2007 Mercedes-Benz C280 2019-08-02T22:00:37+00:00